It happened later than I wanted, but I finally got my computer up and working again. It is nice being able to work from my desk again though I can say I was surprised at how well I was able to adapt to using a laptop to do all of my work. I know it was only down for just over a week; it did feel quite a bit longer than that. To top things off I got a cold. The nice thing is that it is a long weekend so I can sleep a lot if necessary.
I should finally be able to print tomorrow. What should I print...? I have a few things in mind. Past that there is not much else to say this week. Have a good Labor Day.
Thank you everyone for your support, and for stopping by.
(All links open in new tab)
We talk about our printers new, old, and the changes we want to make to the. We also discuss copyright and recent rumblings dealing with copyright within the 3D printing realm.
You can download or listen to the track on SoundCloud and directly off our main page. You can also find us on iTunes and YouTube!
Links to things we discuss (opens in new window/tab):
NOTE: Acetone has a boiling point of 56-57°C. Please us extreme caution if you decide to heat acetone when making slurry or perform ABS smoothing.
Correction: Chuck Hellebuyck was referred to as Chuck Headly. A thousand apologies to Chuck! We will make sure Andrew is beaten for is insolence. ;)